Suzuki 2006 SX4, Руководство по обслуживанию

Страница: 696 / 1478

5A-108 Automatic Transmission/Transaxle:
2) Apply A/T fluid to new O-rings and install new O-
rings to forward clutch piston.
3) Press forward clutch piston to input shaft.
NOTE
Do not twist or deviate O-rings during
installation.
4) Apply A/T fluid to new O-rings and install O-rings to
direct clutch piston.
5) Press direct clutch piston to input shaft.
NOTE
Do not twist or deviate O-rings during
installation.
6) Install direct clutch piston return spring (2).
7) Using special tool and hydraulic press, compress
direct clutch piston return spring (2) until spring seat
is pushed down to 1 – 2 mm (0.039 – 0.078 in.) lower
than snap ring groove and install snap ring (1).
Special tool
(A): 09926–95420
(B): 09940–51710
NOTE
• When installing return spring, be careful
so that return spring will not fall or tilt.
• Do not align opening in snap ring with lug
of direct clutch piston return spring at its
retainer section.
CAUTION
!
Be careful when applying pressure, for
overpressure will cause plate section of
direct clutch piston return spring to deform.
8) Install separator plates “S”, friction plates “F” and
retaining plate “R” in the following order.
S
→
F
→
S
→
F
→
S
→
F
→
S
→
F
→
R
9) Install snap ring (1).
NOTE
Make sure that opening end of ring is not
aligned with groove section of input shaft.
10) Install separator plates “S”, friction plates “F” and
retaining plate “R” in the following order.
S
→
F
→
S
→
F
→
S
→
F
→
S
→
F
→
R
NOTE
Make sure that flat end of retaining plate face
toward piston side.
11) Install snap ring (1).
NOTE
Make sure that opening end of ring is not
aligned with groove section of input shaft.
(B)
(A)
2
1
I4RH01510259-01
1
F
S
R
I4RH01510126-01
1
F
R
S
I4RH01510127-01