Suzuki 2006 SX4, Руководство по обслуживанию

Страница: 336 / 1478

1G-15 Fuel System:
Installation
CAUTION
!
• When connecting joint, clean outside
surfaces of pipe where joint is to be
inserted, push joint into pipe till joint lock
clicks and check to ensure that pipes are
connected securely, or fuel leak may
occur.
• Never let the fuel hoses touch the wheel
speed sensor harness (if equipped).
1) If parts have been removed from fuel tank, install
them before installing fuel tank to vehicle.
2) Raise fuel tank (1) with jack (2) and connect fuel
pump connector (3), ground wire (4) and clamp wire
harness.
Tightening torque
Ground wire bolt (a): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
3) Install fuel tank to vehicle, and tighten new fuel tank
bolts to specified torque.
Tightening torque
Fuel tank bolt (b): 45 N·m (4.5 kgf-m, 33.0 lb-ft)
4) Connect fuel filler hose (1) and breather hose (2) to
filler neck (3) as shown in figure, and clamp them
securely.
Tightening torque
Fuel tank hose clamp (a): 1.5 N·m (0.15 kgf-m,
1.0 lb-ft)
5) Connect fuel feed hose (1) and vapor hose (2) to
each pipe as shown in figure, and clamp them
securely.
6) Install exhaust center pipe referring to “Exhaust Pipe
and Muffler Removal and Installation in Section 1K”.
7) Install propeller shaft (4WD model) referring to
“Propeller Shaft Assembly Removal and Installation
in Section 3D”.
8) Install EVAP canister referring to “EVAP Canister
Removal and Installation in Section 1B”.
9) Connect negative (–) cable at battery.
10) With engine OFF, turn ignition switch to ON position
and check for fuel leaks.
(b)
(b)
1
2
3
4
(a)
I7RW01170010-01
1
(a)
2
3
I6RW0C170003-01
1
2
I5RW0A170018-01