Suzuki 2006 SX4, Руководство по обслуживанию

Страница: 688 / 1478

5A-100 Automatic Transmission/Transaxle:
15) Install separator plates “S”, friction plates “F” and
retaining plate “R” in the following order.
S
→
F
→
S
→
F
→
R
NOTE
Make sure that 2nd brake piston return
spring is inserted in 2nd coast brake
retaining plate boss.
16) Using special tool and hydraulic press (1), compress
2nd brake piston return spring (2) until spring seat is
pushed down to 1 – 2 mm (0.039 – 0.078 in.) lower
than snap ring groove and install snap ring.
Special tool
(A): 09941–51010
CAUTION
!
Be careful when applying pressure, for
overpressure will cause plate section of
spring to deform.
NOTE
• When installing return spring, be careful
so that return spring will not fall or tilt.
• Do not align opening in snap ring with lug
of 2nd brake piston return spring at its
retainer section.
17) Measure 2nd brake piston stroke again, using
special tools.
If measured piston stroke exceeds specified value,
check for an improper installation.
Special tool
(A): 09900–20607
(B): 09900–20701
2nd brake piston stroke
Standard: 1.91 – 2.69 mm (0.075 – 0.106 in.)
18) Measure 2nd coast brake piston stroke, using
special tools.
If measured piston stroke exceeds specified value,
check for an improper installation.
Special tool
(A): 09900–20607
(B): 09900–20701
2nd coast brake piston stroke
Standard: 0.82 – 1.66 mm (0.032 – 0.156 in.)
19) Install 2nd coast brake thrust washer (1).
If measured piston stroke exceeds specified value,
check for an improper installation.
NOTE
Make sure lugs of 2nd coast brake thrust
washer align with 2nd coast brake piston
return spring.
1
(A)
2
I4RH01510105-01
(A)
(B)
I4RH01510106-01
(A)
(B)
I4RH01510107-01
1
I4RH01510108-01