Suzuki 2006 SX4, Руководство по обслуживанию

Страница: 539 / 1478

Rear Brakes: 4C-4
2) Install new slide pin boots (1) to brake caliper carrier.
3) Apply rubber grease to slide pins, then install slide
pin (2) to front side and slide pin (3) to rear side of
brake caliper carrier.
NOTE
Be sure not to install wrongly because the
shape of slide pins are different as shown
below.
4) Pass parking brake cable (1) through bracket (3) of
caliper.
5) Hang parking brake cable on lever (2) as follows.
NOTE
Make sure that lever (4) contacts pin (5).
6) Install brake pads and caliper referring to “Rear Disc
Brake Pad Removal and Installation”.
7) Connect flexible hose (4) with new washers (5) to
caliper and brake pipe temporarily by hand. Then
install clip (2).
8) Tighten flexible hose joint bolt (3) and brake pipe
flare nut (1).
WARNING
!
Make sure that flexible hose is not twisted
when tightening joint bolt. If it is twisted,
reconnect it using care not to twist it.
Tightening torque
Flexible hose joint bolt (a): 23 N·m (2.3 kgf-m,
17.0 lb-ft)
Brake pipe flare nut (b): 16 N·m (1.6 kgf-m, 12.0
lb-ft)
9) Install brake cable clip (1) securely to bracket (2).
F: Vehicle front
I7RW01432017-01
I7RW01432012-04
1(b)
4
2
3(a)
5
I7RW01432002-02
1
2
I6RS0B431027-01