Suzuki 2006 SX4, Руководство по обслуживанию

Страница: 481 / 1478

Differential: 3B-43
23) Remove differential cover.
24) To measure bevel gear backlash, set dial gauge at
right angle to bevel gear tooth, fix drive bevel pinion
and read dial gauge while moving bevel gear.
If bevel gear backlash is out of specification, repeat
Step 22).
NOTE
• Be sure to apply measuring tip of dial
gauge at right angles to convex side of
tooth.
• Measure at least 4 points on drive bevel
gear periphery.
Drive bevel gear back lash
0.1 – 0.2 mm (0.004 – 0.008 in.)
Special tool
(A): 09900–20607
(B): 09900–20701
25) As final step, check gear tooth contact as follows.
a) After cleaning 10 drive bevel gear teeth, paint them with gear marking compound evenly by using brush (1) or
sponge etc.
b) Turn gear to bring its painted part in mesh with drive bevel pinion and turn it back and forth by hand to repeat
their contact.
c) Bring painted part up and check contact pattern, referring to the following table. If contact pattern is not normal,
readjust or replace as necessary according to instruction in the table.
NOTE
Be careful not to turn drive bevel gear more than one full revolution, for it will hinder accurate check.
I5RW0A320057-01
A: Paint gear marking compound evenly
Tooth Contact Pattern Diagnosis and Remedy
Normal
High Contact
Pinion is positioned too far from the center of drive
bevel gear (1).
• Increase thickness of pinion (2) height adjusting
shim and position pinion closer to gear center.
• Adjust drive bevel gear backlash to specification.
1
A
I5JB0A321040-02
I5JB0A321041-05
IYSQ01321072-01
IYSQ01321073-01