Supermicro SuperServer 8048B-TRFT, Руководство пользователя

Страница: 7 / 84

1-2 1-3
Chapter 1: Introduction SUPERSERVER 8048B-TRFT USER'S MANUAL
1-2 Serverboard Features
At the heart of the SuperServer 8048B-TRFT lies the X10QBi, a quad processor
serverboard based on the Intel® C602J chipset and designed to provide maximum
performance. The X10QBi acts as a baseboard, into which an I/O card and memory
cards may be installed.
The sections below cover the main features of the X10QBi serverboard (see Figure
1-1 for a block diagram of the chipset).
Processors
The X10QBi supports four Intel® Xeon® E7-4800/8800 v2 or v3 series processors
(Socket R1 LGA 2011). Please refer to the serverboard description pages on our
website for a complete listing of supported processors (
www.supermicro.com ).
Memory
The X10QBi uses eight memory cards that install into the eight memory slots on
the serverboard. Two cards are assigned to each CPU as follows: SMI slots P1M1/
P1M2 for CPU1, SMI slots P2M1/P2M2 for CPU2, SMI slots P3M1/P3M2 for CPU3
and SMI slots P4M1/P4M2 for CPU4.
Each memory card may be populated with up to 12 DIMMs. With all cards fully
populated, the system will support up to a total of 6 TB of DDR3-1600/1333/1066/800
ECC RDIMM/LDIMM memory. See Chapter 5 for details.
Note: Check the Supermicro website ( www.supermicro.com ) for the latest memory
support information.
Serial ATA
A SATA controller is integrated into the C602J chipset to provide two SATA 3.0
and four SATA 2.0 ports, which support RAID 0, 1, 5 and 10. The SATA drives are
hot-swappable units.
PCI Expansion Slots
The X10QBi serverboard has four PCI Express 3.0 x16 slots and seven PCI Express
3.0 x8 slots.
1-3 Server Chassis Features
The following is a general outline of the main features of the SC848XTS server
chassis.
System Power
The SC848XTS chassis model includes four 1620W power supplies consisting of
two active and two backup power modules. In the event your power supply fails,
replacement is simple and can be accomplished without tools.
SATA Subsystem
The SC848XTS supports up to 24 3.5" hot-swap hard drives. These drives are
connected to a backplane that provides power and control.
Front Control Panel
The SC848XTS chassis includes a control panel below the left handle of the chassis.
The control panel provides you with system monitoring and control. LEDs indicate
system power, HDD activity, network activity, an information LED and power supply
failure. A main power button and a system reset button are also included.
I/O Ports
The chassis provides eight full-height, full-length expansion card slots, a COM port,
two USB 2.0 ports and, on the I/O card, a VGA port, two 10 Gb Ethernet ports and
a dedicated IPMI Ethernet port.
Cooling System
Four 9-cm and three 8-cm system fans are powered from the chassis and controlled
via IPMI.
Air Shrouds
The SC848XTS chassis includes one mylar air shroud, which directs the airflow
where cooling is needed. Always use the air shroud included with your server.
Note: if four memory modules are installed, an additional air shroud must be used
(p/n MCP-310-41805-0B). See Chapter 6 for details.