Supermicro SuperServer 8048B-TRFT, Руководство пользователя

Страница: 32 / 84

Chapter 5: Advanced Serverboard Setup
5-5 5-4
SUPERSERVER 8048B-TRFT USER'S MANUAL
5-4 Processor and Heatsink Installation
Warning: When handling the processor package, avoid placing direct pressure on
the label area.
Notes:
•
Always connect the power cord last, and always remove it before adding,
removing or changing any hardware components. Make sure that you install the
processor into the CPU socket before you install the CPU heatsink.
•
If you buy a CPU separately, make sure that you use an Intel-certified multi-
directional heatsink only.
•
Make sure to install the system board into the chassis before you install the
CPU heatsink.
•
When receiving a server board without a processor pre-installed, make sure that
the plastic CPU socket cap is in place and none of the socket pins are bent;
otherwise, contact your retailer immediately.
•
Refer to the Supermicro website for updates on CPU support.
•
When one CPU is installed, be sure to installed to CPU Socket 1 first.
Installing the Processors
1. There are two load levers on the LGA2011 socket. To open the socket cover,
first press and release the load lever labeled 'Open 1st'.
OPEN 1st
Press down on
load lever labeled
'Open 1st'.
OPEN 1st
Connecting the Control Panel
JF1 contains header pins for various front control panel connectors. See Figure 5-3
for the pin locations of the various front control panel buttons and LED indicators.
Even and odd numbered pins are on opposite sides of each header.
All JF1 wires have been bundled into single keyed ribbon cable to simplify their
connection. The red wire in the ribbon cable plugs into pin 1 of JF1. Connect the
other end of the cable to the Control Panel printed circuit board, located just behind
the system status LEDs in the chassis.
See the Connector Definitions section in this chapter for details and pin descriptions
of JF1.
Figure 5-3. Front Control Panel Header Pins (JF1)
Power Button
Red (OH/Fan Fail/
PWR FaiL)
1
NIC1 Link LED
Reset Button
2
Power Fail LED
HDD LED
FP PWRLED
Reset
PWR
3.3V
3.3V
Blue Led Cathode
(UID)
Ground
Ground
19 20
3.3V
X
Ground
NMI
X
NIC2 Link LED
NIC2 Active LED
NIC1 Active LED
Note: There are four CPU sockets located on the X10QBi baseboard. Populate the
desired number of CPUs on the board starting with CPU Socket 1.
Figure 5-2. Rear I/O Ports (Horizontal)
Rear I/O Ports
1. USB Port
2. USB Port
3 Serial (COM) Port
2 1 3