Supermicro SuperServer 8048B-TRFT, Руководство пользователя

Страница: 31 / 84

Chapter 5: Advanced Serverboard Setup
5-3 5-2
SUPERSERVER 8048B-TRFT USER'S MANUAL
5-3 Control Panel Connectors and I/O Ports
The I/O ports on the are located at the rear of the system. See Figures 5-1 and 5-2
for the locations of the various I/O ports. See Figure 6-1 for the location of these
ports on the rear of the chassis.
Figure 5-1. Rear I/O Ports (Vertical)
Rear I/O Ports
1. VGA Port
2. X540 10 Gb LAN2 Port
3. X540 10 Gb LAN1 Port
4. Dedicated IPMI LAN Port
5 UID Switch
5-2 Connecting Cables
Now that the processors are installed, the next step is to connect the cables to
the serverboard.
Connecting Data Cables
The cables used to transfer data from the peripheral devices have been carefully
routed in preconfigured systems to prevent them from blocking the flow of cooling
air that moves through the system from front to back. If you need to disconnect
any of these cables, you should take care to reroute them as they were originally
after reconnecting them (make sure the red wires connect to the pin 1 locations). If
you are configuring the system, keep the airflow in mind when routing the cables.
The following cables need to be connected for the SuperServer 8048B-TRFT
system:
•
One (1) round 76-cm (30") 16-to-16-pin ribbon FP cable (CBL-0071L)
•
One (1) power extension cable; one HDD to two HDD and two FDD
(CBL-0099)
•
Two (2) cross-over iPass to four SATA HDDs cables (CBL-0294L-10)
2
1
5
3
4