Supermicro SuperServer 8048B-TRFT, Руководство пользователя

Страница: 49 / 84

Chapter 6: Advanced Chassis Setup
6-5 6-4
SUPERSERVER 8048B-TRFT USER'S MANUAL
6-4 Accessing the Inside of the System
Removing the Chassis Cover
You will need to access the inside of the system to complete certain procedures
such as replacing fans.
Removing the Chassis Cover
1. Power down the system and unplug the cords from the back of the power
supplies.
2. Remove the screws securing the top cover to the chassis if these screws are
present.
3. Simultaneously press the release tabs to free the top cover from the locked
position.
4. Slide the top cover toward the rear of the chassis.
5. Lift the top cover off the chassis.
Caution: Except for short periods of time, do NOT operate the server without the
cover in place. The chassis cover must be in place to allow proper airflow and prevent
overheating.
Figure 6-4. Accessing the Inside of the System
Figure 6-3. Installing a Hard Drive into a Carrier
Warning: Except for short periods of time (swapping hard drives), do not operate the
server with the hard drive bays empty.
Installing a Hard Drive to the Carrier
1. Remove the two screws securing the dummy drive to the drive carrier and
remove the dummy drive. Place the hard drive carrier on a flat surface such
as a desk, table or work bench.
2. Slide the hard drive into the carrier with the printed circuit board side facing
down.
3. Carefully align the mounting holes in both the drive carrier and the hard drive.
4. Secure the hard drive to the carrier using six screws.
5. Install the drive carrier back into the chassis. Make sure to close the drive
carrier handle to lock the drive carrier in place.
Drive Carrier
SATA
Hard Drive
1
4
1
4
Remove these
screws
(if present)
1
3
1
3
1
2
1
4
1
5