Sunsystem BURNiT PM Comfort 13 Plus, Руководство по обслуживанию

Страница: 9 / 47

Installer / Service Manual BURNiT PM Comfort
Plus
9 –ЕN
3.3. Exhaust gas system
The correct installed system for exhaust gases is of extreme importance.
It is obligatory the installation to be performed by an authorized installer / service
BURNiT !
Recommended parameters for installing the exhaust gas system:
Model 13 kW 25 kW
Draught chimney Ра 12 12
Exhaust gases flow g/s 5,3 5,3
CO measured for 13% oxygen % 0,015 0,015
Temperature of exhaust gases С° 180 180
3.4. Exhaust gas system requirements:
Exhaust gas system meet the following requirements:
• made of suitable materials.
• hermetically sealed - silicone gaskets on chimney tubes
• to be suitable for wok mode under high pressure and temperature 200°C -250°C
(recommended thickness of the pipes no less than 1mm).
• In case you want to connect the pellet stove to the already existing exhaust gas
system (chimney), its condition must be validated by an authorized installer.
• It is recommended the exhaust gas system (chimney) to be cleaned periodically.
3.5. Type of tubes for exhaust gas system (chimney)
The tubes must be solid, smooth inside, mad of steel and must be accompanied by
silicone gaskets.
The diameter of tubes long up to 3 m. must be 80 mm.
The diameter of tubes long more than 3 m. must be minimum 100 mm. as it is
necessary to obtain the required draught of the chimney (see 3.3).
The length is calculated as the requirements in 3.1 are kept.
ATTENTION! Do not connect the exhaust gas system to a chimney in which already
is connected another stove, boiler or ventilation system!