22
Sun Fire V445 Server Installation Guide • November 2006
Securing the Cords and Cables to the
Cable Management Arm
Note –
This procedure illustrates how to secure the power cords and the Ethernet
cable to the cable management arm. Your server might use additional cables.
1. If necessary, slide the chassis smoothly out of the cabinet about 3 inches (8 cm).
Sliding the server out of the cabinet provides easier access to the cable management arm.
2. Locate the metal fingers on the first and third sections of the cable management
arm.
3. Locate the center section of the cable management arm.
The Velcro straps enable you to route the cables and cords and secure them to
the cable management arm.
4. Route the cables into the fingers in the first section of the cable management arm.
Leave enough slack in the cables to ensure that the hinges operate freely without
crimping or binding the cables.
FIGURE 2-13
Routing cables through the cable management arm
