Sun Microsystems SPARC T5120, Руководство по обслуживанию

Страница: 66 / 228

50 Sun SPARC Enterprise T5120 and T5220 Servers Service Manual • July 2009
The database that contains the list of disabled components is referred to as the ASR
blacklist (
asr-db
).
In most cases, POST automatically disables a faulty component. After the cause of
the fault is repaired (FRU replacement, loose connector reseated, and so on), you
might need to remove the component from the ASR blacklist.
The following ASR commands enable you to view and add or remove components
(
asrkeys
) from the ASR blacklist. You run these commands from the ILOM
->
prompt.
Note – The
asrkeys
vary from system to system, depending on how many cores
and memory are present. Use the
show components
command to see the
asrkeys
on a given system.
After you enable or disable a component, you must reset (or power cycle) the system
for the component’s change of state to take effect.
Related Information
■
“Display System Components” on page 51
■
“Disable System Components” on page 52
■
“Enable System Components” on page 53
▼
Display System Components
The
show components
command displays the system components (
asrkeys
) and
reports their status.
Command Description
show components
Displays system components and their
current state.
set
asrkey
component_state=Enabled
Removes a component from the
asr-db
blacklist, where asrkey is the component to
enable.
set
asrkey
component_state=Disabled
Adds a component to the
asr-db
blacklist,
where asrkey is the component to disable.