Finishing Cont.
☐
Connect your marks to make a short line right
down the middle of the deck.
☐
Peel the protective film from your windscreen.
☐
Position the wind screen so that the notch in
the middle of the bottom edge is over the line
you have drawn. Ensure the windscreen is
perpendicular to this center line.
☐
Press the spikes on the bottom edge of the
windscreen into the deck of the fuselage,
creating two small holes.
☐
Remove the windscreen and wipe away the
centerline mark with a little acetone and a
paper towel.
☐
Replace the windscreen. Tilt it back until the
bottom curve of the windscreen mates
perfectly with the deck and bond with medium
CA.
Build Instructions
SkyScout 480
- Build Instructions © 2010 Stevens AeroModel, all rights reserved.
!
Page 49
Holes
