Project Checklist
Kit Contents
☐
Laser-cut wood package, 21 Laser Cut Sheets (See inventory on following pages.)
☐
1 - Scalloped turtle deck fairing, part “F27” (1/64 plywood)
2 - Pushrod tubing, .032 i.d. x 18 in. (.070 o.d. yellow nylon)
3 - Pushrod wire, .032 x 18 in.
☐
Photo Illustrated instruction manual (No plan set is required to complete this model.)
☐
Landing Gear and Empennage Template Sheet (11x17)
☐
1 - Cowl (white styrene)
☐
2 - Landing gear struts (Front and Rear), pre-bent
☐
Long Hardware Bag (3 x 24 in.)
1 - Vintage tire material, 24 in. length 1/2 in. dia. rubber cord [*]
2 - Flying struts (front), laser-cut
2 - Flying struts (rear), laser-cut
2 - Servo wire paper guide tubes, 18 in. length
2 - 1/4 in. dia. x 24 in. length Balsa Dowel Stock (Leading Edge)
3 - 3/32 in. x 3/16 in. x 24 in. Balsa Stock (Fuselage Stringers)
☐
Large Hardware Bag (4 x 6 in.)
1 - 1/4 in. x 4 in. Heat Shrink Tube [*]
1 - Basswood Elevator Joiner “E5” [*]
1 - 1 in. Length Silicone Fuel Tubing [4005]
1 - PTEG Laser Cut Windshield [*]
1 - Nylon Tail Skid (DUB853) [4023]
2 - 1/8 in. dia. x 2 in. length hardwood dowel [1017]
3 - CA Hinges [4024]
10 - Du-Bro Micro II Control Horns [4020]
☐
Small Hardware Bag (2 x 3 in.)
2 - Hairpin Cotter Pins (98335A024) [4011]
2 - #4 Nylon Flat Washers [3018]
2 - 3/16 in. dia. Neo. Magnets [4014]
2 - (.188) 3/16 in x (1.50) 1-1/2 in. Brass Tube (Axles) [5001]
2 - (.219) 7/32 in. x (1.25) 1-1/8 in. Brass Tube (Wheel Bearings) [5003]
4 - (.219) 7/32 in. x (.156) 5/32 in. Brass Tube (Wheel Collars) [5002]
4 - Mini EZ Connectors (DUB845) [4021]
4 - #0 x 3/16 in. Screws [3010]
4 - 4-40 x 3/8 in. Machine Screws [3007]
4 - 4-40 Blind Nuts [3001]
4 - 1/16 in. x 1/4 in. Aluminum Tube [2010]
4 - 1/8 in. x 7/16 in. Aluminum Tube [2009]
8 - Steel Landing Gear Straps (DUB158) [3017]
12 - Micro EZ Links (DUB849) [4017]
16 - #2 x 1/4 in. Screws [3011]
Build Instructions
SkyScout 480
- Build Instructions © 2010 Stevens AeroModel, all rights reserved.
!
Page 3
