Finishing Cont.
☐
Trim about 1/16 in. off of the posts of two
Micro II control horns [DUB919].
☐
Open holes in the covering on the
LOWER
LEFT
side of the elevator. Bond one control
horn in place with medium CA.
☐
Open holes in the covering on the
RIGHT
side of the rudder, and bond one control horn
in place with medium CA.
☐
Fit tab on vertical stabilizer through slot in
horizontal stabilizer.
☐
Position tail surfaces on fuselage. Tab on
vertical stabilizer fits in slot in F9. Ensure
surfaces are square to each other and
perpendicular to fuselage.
☐
Double check alignment, then bond surfaces
to fuselage with medium CA.
Build Instructions
SkyScout 480
- Build Instructions © 2010 Stevens AeroModel, all rights reserved.
!
Page 42
Bottom View
Bottom View
