Finishing Cont.
The elevator and rudder will be controlled by
two Hitec HS-55 servos.
☐
Trim one arm off of the large control horn.
☐
Install one Mini EZ Connector [DUB845] in
the middle hole of the control horn, and re-
mount the control horn with the arm 90
degrees to the body of the servo.
☐
Install servos with the arms pointing outward.
☐ ☐
Using one of the 18 in. lengths of .032 in.
wire, make a 90 degree bend 1/8 in. from
one end.
☐ ☐
Open the covering over the ends of the
rudder pushrod housing on the right side.
Build Instructions
SkyScout 480
- Build Instructions © 2010 Stevens AeroModel, all rights reserved.
!
Page 43
