Finishing Cont.
☐
Pass the servo leads through the hole in the
forward decking, through F0, and connect to
the receiver.
☐
Check the alignment of the wing. Measure
from the aft end of the fuselage to the rear of
each wing tip. Both sides should be equal. If
they are not, double check that the wire
fittings on the end of the flying struts are the
correct length, and that the cabane struts are
seated in their sockets properly. When you
are satisfied that the wing is on straight, bond
the cabane struts in their sockets with
medium CA.
☐
You didn’t miss the underlined section
above right? ...BOND THE CABANE
STRUTS IN THEIR SOCKETS....
☐
Radiator:
Locate the grooved balsa parts
RA1, the ply parts RA2, and the balsa parts
RA3 and RA4.
☐
Stack three RA1’s together, ensuring that the
grooves are aligned, and bond with thick CA.
Repeat for the remaining three RA1’s.
☐
Fit the ply RA2’s into the grooves in both
stacks of RA1’s. Square the assembly on a
flat surface and bond with thin CA.
Build Instructions
SkyScout 480
- Build Instructions © 2010 Stevens AeroModel, all rights reserved.
!
Page 57
RA1
RA2
RA3
RA4
RA4
RA1
RA1
RA1
RA2
