EN
22
763.134 Z02 1913 coolcept_fleX
4
Installing the inverter
4.1
Safety instructions for installation
DANGER
Voltage
Under solar radiation, the PV generators and cables may be energised.
There is the risk of death due electrocution and electric discharge.
►
Disconnect the DC and AC connections from the power source prior to
any work on the inverter:
–
Switch off all AC line circuit breakers and secure them against being
switched on again.
–
Set the DC disconnector on the inverter to position '0' and secure it
against being switched on again.
–
Disconnect the plugs of the DC cables (follow the instructions of the
manufacturer).
–
Disconnect AC plug from the inverter: press locking hook on the
AC plug slightly an remove AC plug.
►
Only have specialists carry out any installation work.
►
Only connect the cables to the inverter when it is requested by the instruc-
tions.
►
Only connect SELV circuits to the RJ45 socket.
NOTE
Improper installation my cause performance reduction or damages on the in-
verter.
►
Ensure that the installation site meets the following requirements:
–
The mounting surface and immediate surrounding must be: perma-
nently fixed, vertical, level, of low flammability, and not subject to con-
stant vibration.
–
The ambient conditions are within the permissible range (refer to chap-
ter 12).
–
Open spaces are provided for around the device (above and under-
neath ≥ 200 mm, to the sides and in front ≥ 60 mm).
►
Do not install the device in stables where animals are kept.
►
Avoid exposure to direct sunlight of the device.
►
Ensure that the display can be easily read on the installed device.
