EN
763.134 Z02 1913 coolcept_fleX
9
2
Safety
NOTE
Any repair work may only be carried out by the manufacturer's customer
service department.
2.1
General safety instructions
•
This document must be kept to hand at the site of use of the inverter.
In case of a change of ownership pass on the document with the inverter.
•
This document must have been read and understood in full before installing and using
the inverter.
•
Incorrectly connected components may cause damage to the inverter.
•
If one of the following components is damaged, immediately take the inverter out of
operation and disconnect it from the grid and the PV generators:
- Inverter (not functioning, visible damage, smoke, penetration of liquid etc.)
- Cables
- PV generators
•
Do not switch on the system again until it has been repaired and checked by a suitably
qualified and authorised technical specialist.
•
Dangerous voltages may be present for up to 10 minutes after disconnecting the in-
verter from the voltage sources.
•
Disconnect inverter from both voltage sources (power grid and PV generator) prior to
any work on the inverter.
•
Always carry out the measures described in this document in the specified sequence.
•
Do not change nor remove any factory-applied labels on the inverter.
•
Do not open the inverter. Danger to life! Opening the inverter will also void any warranty.
•
Do not cover the inverter.
•
Keep children away from the inverter.
•
Follow the instructions of manufacturers of the connected components.
•
Follow the general and national safety and accident prevention regulations.
The inverter does not cause any inrush current.
