EN
763.134 Z02 1913 coolcept_fleX
43
•
"Grid voltage": voltage at the inverter connection
1)
•
"Grid frequency": frequency of the public grid
•
"Internal temp": internal temperature of the inverter
•
"Derating": reason for the power reduction
Possible reasons:
- Internal temperature too high
- User default for power limit
- Frequency too high
- Control by grid operator (feed-in management)
- Delayed power increase after start
•
"Max. daily power": maximum power of the current day
2)
•
"Abs. max. power": highest power fed in
2)
•
"Day max. yield": max. achieved day yield
2)
•
"Operating hours": operating hours on the grid (including hours at night)
•
"Total yield ": yield since commissioning
•
"CO
2
saving": CO
2
saving since commissioning
1)
Measured value is always displayed (it is not possible to switch it off)
2)
Can be reset to zero via "Settings" > "Reset max. vals.".
RS485 address
The address of the RS485 connection can be entered.
Network
By pressing "SET", you can go to the following submenus: "DHCP", "IP address", "Subnet
mask", "Gateway", "DNS", and "Web portal", which itself has submenus.
To set up the TCP/IP network connection, an input of parameters is required.
Without knowing the parameter it is not possible to set up the TCP/IP network
connection.
►
If necessary, seek the advice of another specialist.
DHCP is activated in the inverter ex factory. Therefore, the IP address is automatically as-
signed to the network.
