EN
763.134 Z02 1913 coolcept_fleX
45
7.4.7 Service
Legally required parameters can be changed in the service menus. Any
change may have a negative effect on the performance of the inverter and
possibly even break a law.
►
Only specialists that can ensure that the changes do not violate any appli-
cable regulations and standards are allowed to perform any changes on
the parameters of the service menus.
To go to the service submenus, the "
" operating buttons
must be pressed simultaneously for 3 seconds.
Some dialogues of the service menus are password-protected.
This password can be obtained from Steca's support depart-
ment (refer to chapter 15).
Setting the reactive power characteristic curve
Setting the reactive power characteristic curve is only required if this is specified for the
selected country.
Deleting the country setting
The selected country setting can be deleted. This task is password-protected (contact to
Steca is required). The inverter restarts and displays the guided initial commissioning
again.
Voltage limits
The voltage limits (peak values of the voltage) can be set by de-
fining the following values:
•
"Lower value"
•
"Upper value"
