STATUS SCIENTIFIC CONTROLS
Installation, Commissioning & Routine Gas Testing
FGD10A-M Gas Detector
TD18/032
Issue:
10
Change Note:
1869
Page 44
9.1.12.2 ConfigData:
The parameters
displayed via ‘cycling pages‘ are as follows for IR sensors only:
The ConfigData optio
n will be “greyed out” for non IR sensors and if thus selected,
the message “
ConfigData is for Infra Red Sensors only
!
” will be displayed
instead.
Diagnostics1
Menu=Exit
ConfigVer:
8
Sensor Type:
Uni
Mode bits
A3
Fsd0
5.0
Fsd1
100
Diagnostics1
Menu=Exit
2.0
3.0
Fsd2
Fsd3
Warmup (s):
45
Diagnostics1
Menu=Exit
RANGES ENABLED:
RANGE1:
ON
RANGE1:
RANGE1:
RANGE1:
OFF
OFF
OFF
ConfigVer is the version of Config data structure as detailed in TDS0045
Alarm count gives the total number of alarm events since the FGD10AM was
powered up. The counter can only be reset by cycling the power supply to the
FGD10AM. For further information on config data refer to
9.1.12.3 CommsData
This option is primarily for use by SSCL in diagnosing any possible comms issues
with Dynament IR sensors. In summary P2Psuccess shows the number of
successful requests serviced by the IR sensor. The other parameters are errors
specific to the Premier Sensor Communications Protocol.firmare. All these
counters can only be reset by cycling the power supply to the FGD10AM.
Note: This option is only available if a Premier IR sensor is fitted. The ConfigData
option will be “greyed out” for non IR sensors and if thus selected, the message
“
CommsData is for Infra Red Sensors only
!
” will be displayed instead.
Diagnostics 1
Exit
P2PSuccess:
11669
0
ComTimeouts:
P2PcksumFails:
P2PTimeouts:
P2PUnexbytes:
0
0
0
