Spellman SLM SERIES, Инструкция по эксплуатации

Страница: 116 / 122

6.6.19 Program User Configs
Description:
The host requests that the firmware program the user configs.
Direction:
Host to supply
Syntax:
<STX><09><,><ARG1><,><ARG2><,><ARG3><,><ARG4><,><ARG5><,
><ARG6><,><ARG7><,><ARG8><,><ARG9><,><CSUM><ETX>
Where:
<ARG1> = 1 = ROV enabled, 0 = ROV disabled in ASCII format.
<ARG2> = 0-110 in ASCII format representing the overvoltage
percentage.
<ARG3> = 1-600 in ASCII format representing the ramp rate in seconds
from .1 to 60sec.
<ARG4> = 1 = AOL enabled, 0 = AOL disabled in ASCII format.value.
<ARG5> = 0-20 in ASCII format representing the arc count.
<ARG6> = 0-60 in ASCII format representing the arc period in seconds.
<ARG7> = 0-500 in ASCII format representing the arc quench time in milli-
seconds.
<ARG8> = 1 = ARC re-ramp enabled, 0 = ARC re-ramp disabled in
ASCII format.
<ARG9> = 1 = No Arc detect, 0 = Arc detect in ASCII format.
Example:
<STX>09,1,50,100,0,10,30,250,1,0, <CSUM><ETX>
Response:
<STX><09><,><$><,><CSUM><ETX>
<STX><09><,><ARG><,><CSUM><ETX>
where <ARG> = error code
Error Codes
1 in ASCII format = Invalid Arc Rate warning message:
An invalid arc rate(Time period/Arc Count) of more than 1 arc per second has
been entered, these values along with the other variables in the command string
have been disregarded by the HVPS.
2 in ASCII format = NAD Enabled warning message:
The
N ot A rc D etect mode has been enabled. In this mode the HVPS has
no Arc shutdown protection. The HVPS is designed to handle 1 arc per second.
Exceeding 1 arc per second could cause damage to the HVPS.
HVPS failure
caused by excessive arcing will not be covered under the warranty .
118080-001 REV A
Page 89 of 95