SKF Baker AWA-IV 12 HO, Руководство пользователя

Страница: 87 / 214

NOTE
It is important when comparing waveforms that all settings are the same. If the
scales are different, a valid comparison cannot be made.
5) After the test parameters have been modified as needed, click the
Close
button to
return to the Main window,
Tests
tab.
6) Click on the
Save
button to save the parameter changes, but do not uncheck the
Edit
Test ID
box. You are now ready to test a known-good motor to obtain your Surge
test reference.
Testing a reference motor
1) To obtain the reference test, ensure that the Edit Test ID box in the Tests tab is
checked. Immediately after setting up the test parameters, connect the reference
motor to the analyzer and confirm that the Motor ID displayed on the toolbar is the
reference Motor ID.
2) If you want to ensure that the motor passes all tests, click the Run Auto Test button
then resume the Surge Test reference waveform process when you get to the Surge
Test window. Otherwise, you can click on the Surge Test run button in the Tests tab
and proceed.
3) In automatic mode, the test will commence on its own. For other modes, click on the
All Lead button to start the test. The analyzer will raise the test voltage to the define
level and conduct all defined measurements for each test lead. For a known-good
motor, all tests should pass. When the tests complete, the tester will return you to
the Tests tab (in automatic mode; other modes, click Close to return to the Tests tab.
Figure 71. Surge Test reference waveform acquisition in progress.
PUB CM/I4 71-015 EN V13.2 Static Motor Analyzer—Baker AWA-IV User Manual 67
Baker AWA-IV software overview