SKF Baker AWA-IV 12 HO, Руководство пользователя

Страница: 161 / 214

14) When you are satisfied with the waveform, release the fixture’s test button or
footswitch. The EAR percentage will be saved and an inset bar graph will be
displayed depicting the EAR percentage versus the reference bar’s waveform. If the
bar failed, the EAR bar on the graph will be red.
15) Up to three additional waveforms can be saved during the testing process. If a bar
fails or is of interest, click on one of the Save button in the Save Waveforms section
at the top of the screen and that waveform will be saved along with its bar number;
otherwise, only the reference-to-bar EAR percentage for the bar will be saved.
16) Continue to move the test fixture to the next bar and repeat steps 10–14 for each
bar until all bars have been tested. A maximum of 1,024 bars can be tested.
17) If at any time before you save the full test results you want to retest a bar, you can
enter that bar number directly into the Bar Control field, or use the up and down
arrows to navigate to the bar number, and retest as needed. Retesting will overwrite
the previous data for that bar.
18) The Total Bars Tested number gives you the number of the last bar tested. Add one
to that number to resume testing where you left off.
19) After all bars have been tested, click the Close button. The software will return you
to the Main view Tests tab, which will look similar to the example below.
20) Because this is not an automatic test, you must click on the yellow Save Results
button to save the test results to the database so it can be recalled for further
viewing and to print reports.
Figure 140. Main view Tests tab after testing; Save Results.
PUB CM/I4 71-015 EN V13.2 Static Motor Analyzer—Baker AWA-IV User Manual 141
Using the Baker ZTX with Baker AWA-IV analyzers