Simrad GN70, Руководство оператора и инструкция по установке

Страница: 67 / 100

| 67
Mounting | GN70/MX610/MX612 Operator and Installation Manual
Mounting
General
The standard mounting of the GN70/MX61x display is in-dash or panel mount. If there is a
need to bracket mount the unit, an optional U-bracket assembly can be ordered separately.
Mounting location
The GN70/MX61x unit should be mounted with special regard to the unit’s easy access for
operation and maintenance, environmental protection, temperature range, cable connection
and cable length.
Survey the front and back of the instrument panel where the unit will be mounted before
cutting the mounting hole to make sure there is ample room around the unit and no hidden
electrical wires or other parts will be damaged behind the panel. The panel mounting surface
must be flat and even to within 0.5 mm.
The GN70/MX61x conforms to the appropriate Electromagnetic Compatibility (EMC) stan-
dards, but proper installation is required to get best use and performance from this product.
Ensure adequate separation from other on-board electronics and electrical equipment.
GN70/MX61x control unit
Avoid mounting the GN70/MX61x control unit where it is easily exposed to sunlight, as this
will shorten the lifetime of the display. If this is not possible, make sure the unit is always
covered with the optional protective cover when not in use.
Panel (flush) mount
1.
Attach the mounting template to the selected mounting position.
2.
Drill pilot holes for the 4 hole saw cuts and for the 4 self tapping screws used to secure the
unit. If using M4 machine screws use a 5 mm (0.20 ”) drill bit.
3.
Use a 25 mm (1 “) hole saw to cut the four corner radius.
4.
Cut along the dotted line and remove waste material.
5.
Peel backing off the gasket and apply it to the unit (A).
6.
Connect the cables to the rear of the unit before placing the unit into the console.
7.
Secure the display to the surface with 4 screws (B).
8.
Firmly clip the bezel in place (C).
A
B
C
14