Simrad GN70, Руководство оператора и инструкция по установке

Страница: 27 / 100

| 27
System Configuration | GN70MX610/MX612 Operator and Installation Manual
7.
Press the
CLR
key to exit the data list screen.
8.
Highlight the Close button and press the
ENT
key or press the
CLR
key several times to exit.
You may also press any hot key to directly go to that screen.
Changing baud rate
There are cases where you may need to change the baud rate speed of the NMEA 0183 port
of the MX61xJB to match a NMEA “talker“or “listener”. This can be done using the procedure
below:
1.
Press the
MENU
key.
2.
Scroll to the “Tools and Settings”, then press the knob or the
ENT
key.
3.
Scroll to Network then press the
ENT
key.
4.
Scroll to NMEA 0183 over MX61xJB then press
ENT
.
5.
Scroll to the Port# desired (i.e. Port 1) then press ENT. The MXJB-Ch1 NMEA1 - Device Informa-
tion dialog box will show.
6.
The Configure button will be highlighted at this point, press the
ENT
key to activate the
configure button.
7.
Scroll to Baud rate... 4800, press
ENT
. The baud rate selections are 4800, 9600, 19200 and
38400.
8.
Scroll to the correct baud rate then press
ENT
to accept.
9.
Press the
CLR
key several times or press any hot key to exit.
Diagnostics
The diagnostic page shows details for the NMEA 2000/CAN bus network. This can be
accessed under the Tools & Settings/Network menu.