SII IP-5520, Руководство пользователя

Страница: 57 / 252

2-9
2
Ba
sic O
pe
ra
tio
n
6
Raise the pressure roller up / down lever.
Note
- There are three selectable positions (up,
middle and down) on the pressure roller up
/ down lever. To raise (release) the pressure
roller here, raise the pressure roller up / down
lever to the top position. (
P.2-20 ([How to
switch the pressure])
7
Feed the media between the pressure roller
and grit roller and advance the media until
the leading edge of the media comes out of
the front cover.
Advance the media until the leading edge
of the media comes out at a distance of 200
mm.
When the leading edge of the media comes
out of the front cover, a confirmation beep sounds.
Note
- Depending on the environment, the media may stick to the paper guide and may
be hard to advance. In this case, advance the media while raising it from the paper
guide by holding both edges with hands.
- If the leading edge of a media is curled up or curled down, the media may be
caught in the printer or may not be properly set. If the media is curled too much,
do not use it.
- Be careful that the leading edge of the media does not touch the front cover. If the
roll media tends to roll, stretch it to eliminate the rolling before loading.
- Check that the media edge guard does not enter under the media.
q Media replacement