SII IP-5520, Руководство пользователя

Страница: 74 / 252

2-26
¢
Reference information on media types and heater settings
The heater set temperatures and reference set values (initial values) of print mode
for each type of media are shown in the table below. Change the settings accord-
ing to the media in use.
Media type
Media
selection
Recommended heater temperature
setting
Print mode
After heater Print heater Preheater
Glossy vinyl
chloride
Glossy 45ºC 40ºC 45ºC Normal, bidirectional
Matte vinyl
chloride
Matte 45ºC 40ºC 45ºC Normal, bidirectional
Tarpaulin Banner 45ºC 40ºC 45ºC Normal, bidirectional
It is recommended that temperature of the after heater, print heater, and preheat-
er be set to less than 50°C, 45°C, and 50°C respectively.
Note
- Setting a high temperature for the print heater makes ink fusion better, but may
cause wrinkles in the media or make the print surface matte. Adjust the heater
temperature according to the media type and ambient temperature.
- When the print heater is set to a high temperature, the printer lowers the printing
speed automatically in some cases to maintain stable print quality.
- Set the preheater and after heater temperatures so that they are nearly 5°C higher
than the print heater temperature. Bad temperature balance between preheater/
after heater and print heater may cause wrinkles in the media.
- Setting a high temperature for the print heater may cause print defects.
¢
Heater temperature setting procedure
(1) When a media type is selected when setting a media, initial temperature values
of each heater for the selected media type are displayed on the menu.
(
P.3-30 [(13) AFTER HEATER T],
P.3-31[(14) PRINT HEATER T], [(15) PREHEATER T]
)
g When the initial temperature value is set, the heater is turned on.
(Heating does not start until print starts.)
g When the initial temperature value is set to [**], the heater is turned off.
(The heater set temperature is not displayed.)