Siemens simovert masterdrives, Справочник

Страница: 1502 / 1547

03.2010
Siemens AG 6SE7087-6QX70 (Version AL)
SIMOVERT MASTERDRIVES Compendium Motion Control
15
Number / Alarm Cause Counter-measure
A029
I2t motor The parameterized limit value for the I2t
monitoring of the motor has been exceeded. Motor load cycle is exceeded!
Check the parameters:
P382 Motor Cooling
P383 Mot Tmp T1
P384 Mot Load Limits
A032
PRBS Overflow An overflow has occurred during recording
with noise generator PRBS Repeat recording with lower amplitude
A033
Overspeed The positive or negative maximum speed has
been exceeded. - Increase relevant maximum speed
- Reduce regenerative load (see FD 480)
A034
Setpoint/actual value
deviation Bit 8 in r552 status word 1 of the setpoint
channel. The difference between freqeuncy
setpoint/actual value is greater than the
parameterized value and the control
monitoring time has elapsed. Check
- whether an excessive torque requirement is
present
- whether the motor has been dimensioned too
small.
Increase values P792 Perm Deviation Frq/
set/actual DevSpeed and P794 Deviation Time
A036
Brake checkback
"Brake still closed" The brake checkback indicates the "Brake still
closed" state. Check brake checkback (see FD 470)
A037
Brake checkback
"Brake still open" The brake checkback indicates the "Brake still
open" state. Check brake checkback (see FD 470)
A042
Motor stall/block Motor is stalled or blocked.
The alarm cannot be influenced by P805
"PullOut/BlckTime", but by P794 "Deviation
Time" Check
- whether the drive is blocked
- Whether the drive has stalled
A049
No slave
not Compact PLUS At serial I/O (SCB1 with SCI1/2), no slave is
connected or fiber-optic cable is interrupted or
slaves are without voltage. P690 SSCI AnaIn Conf
- Check slave.
- Check cable.
A050
Slave incorrect
not Compact PLUS At ser. I/O the slaves required according to a
parameterized configuration are not present
(slave number or slave type): Analog inputs or
outputs or digital inputs or outputs have been
parameterized which are not physically
present. Check parameter P693 (analog outputs), P698
(digital outputs). Check connectors
K4101...K4103, K4201...K4203 (analog inputs)
and binectors B4100...B4115, B4120...B4135,
B4200...B4215, B4220...B4235 (digital inputs)
for connecting.
A051
Peer baud rate
not Compact PLUS In a peer-to-peer connection a baud rate has
been selected which is too high or too
different. Adjust the baud rate in conjunction with the
SCB boards P701 SCom/SCB Baud Rate
A052
Peer PcD L
not Compact PLUS In a peer-to-peer connection, a PcD length has
been set which is too high (>5). Reduce number of words P703 SCom/SCB
PcD #
A053
Peer Lng f.
not Compact PLUS In a peer-to-peer connection, the pcD length of
transmitter and receiver do not match. Adjust the word length for transmitter and
receiver
P703 SCom/SCB PcD #
A057
TB Param
not Compact PLUS Occurs when a TB is logged on and present,
but parameter tasks from the PMU, SCom1 or
SCom2 have not been answered by the TB
within 6 seconds. Replace TB configuration (software)