Siemens simovert masterdrives, Справочник

Страница: 135 / 1547

03.2010 Parameterization
Siemens AG 6SE7087-6QX70 (Version AL)
SIMOVERT MASTERDRIVES Compendium Motion Control
5-13
5.4.2 Connecting, run-up
5.4.2.1 Connecting
The OP1S can be connected to the units in the following ways:
♦
Connection via 3 m or 5 m cable (e.g. as a hand-held input device
for start-up)
♦
Connection via cable and adapter for installation in a cabinet door
♦
Plugging into MASTERDRIVES Compact units (for point-to-point
linking or bus configuration)
♦
Plugging into MASTERDRIVES Compact PLUS units (for bus
configuration)
The cable is plugged into the Sub D socket X103 on units of the
Compact PLUS type and into Sub D socket X300 on units of the
Compact and chassis type.
S IE ME NS
A
S1
B X101
C X103
P
USS-Bus
    
   
  
  
Jog 7 8 9
P
Reset
+/- 0
4 5 6
1 2 3
O
I
Fault
Run
OP1S
US
S v
ia R
S4
85
5
4
3
2
1
9
8
7
6
5
4
3
2
1
9
8
7
6
OP1S side:
9-pole SUB-D socket
Unit side:
9-pole SUB-D connector
Connecting cable
Fig. 5-5 Example: The OP1S in a point-to-point link with the Compact PLUS unit
Carefully penetrate the pre-punched holes for the fixing screws in the
front panel of the Compact units. Plug the OP1S onto the Sub D socket
X300 and screw it tight using the two screws (M5 x 10, accessory pack)
from the inside of the front panel.
On the Compact PLUS rectifier unit, you can plug the OP1S onto the
Sub D socket X320 and lock it in place on the front cover.
Connection via
cable
Plugging into units
of the Compact and
chassis type
Plugging onto
Compact PLUS
rectifier unit