-27-
O
PE
R
AT
IO
N
S
Model W1807 7
1
⁄
2
HP Heavy-Duty Industrial Tilting Spindle Shaper
5.
Pull the tensioning bar forward, and maintain the
pressure on the V-belt as you tighten the locking
handle.
Note:
The V-belt is properly tensioned when there
is about
1
⁄
4
" deflection in the middle of the pulleys
with moderate pressure (see
Figure
24
).
6.
Spin the pulleys to make sure the V-belt is tracking
properly.
7.
Close and secure the motor access door.
������
����������
������
Figure 24.
Testing for correct V-belt
tension.
Table Inserts
The Model W1807 features three table inserts: 2
3
⁄
4
",
5
7
⁄
8
", and 9
7
⁄
8
" I.D. To safely support the workpiece dur-
ing shaping, use these three inserts to keep the opening
around the cutter as small as possible while not interfer-
ing with the cutter rotation.
Note:
Refer to
Table Insert Adjustment
on
Page 42
for
additional information.
Figure 25.
Table inserts installed.
NOTICE
When tilting the spindle, make sure the cutter is clear
of the table inserts and fence boards. Otherwise,
severe damage to the cutter and shaper may result.
Содержание W1807
