Shop fox W1807, Руководство пользователя

Страница: 48 / 64

-42-
SE
RV
IC
E
Model W1807 7
1
⁄
2
HP Heavy-Duty Industrial Tilting Spindle Shaper
SERVICE
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
tech-support@shopfox.biz
.
General
MAKE SURE that your machine is dis-
connected from power during all ser-
vice procedures! If this warning is
ignored, serious personal injury may
occur.
Table Insert Adjustment
The table inserts must be flush with the table on all
sides to correctly support the workpiece and to avoid the
workpiece catching on a raised surface.
The two innermost inserts depend upon the level of the
outermost insert.
To adjust the outermost table insert flush with the
table, do these steps:
1.
DISCONNECT THE SHAPER FROM POWER!
2.
Remove the fence mount and fence assembly.
3.
Lower the spindle all the way down so that the top
is below the surface of the table.
4.
Make sure the two innermost inserts are firmly
secured to the outermost insert, and the set screws
are below the surface of the innermost inserts.
5.
Place a straightedge across the center of the inserts,
as shown in
Figure 50
.
6.
Adjust the four set screws around the perimeter of
the outermost insert until the inserts are flush with
the table.
Note: Move the straightedge 360° around the center
point of the inserts to ensure the inserts are flush
with the table in all directions, as illustrated in
Figure 51 .
Figure 50.
Using a straightedge to adjust
the table inserts.
������������
�������
Figure 51.
Illustration of using
straightedge to adjust table inserts.
Table Insert Adjust