1. Read carefully these Instructions before beginning to install the product. Store these instructions
for future reference
2. Don’t waste product packaging materials and /or circuits.
3. This product was designed and built strictly for the use indicated in this documentation. Any other
use, not expressly indicated here, could compromise the good condition/operation of the product
and/or be a source of danger. SEA S.p.A. declines all liability caused by improper use or different
use in respect to the intended one.
4. The mechanical parts must be comply with Directives: Machine Regulation 2006/42/CE and
following adjustments), Low Tension (2006/95/CE), electromgnetic Consistency (2004/108/CE)
Installation must be done respecting Directives: EN12453 and En12445.
5. Do not install the equipment in an explosive atmosphere.
6. SEA S.p.A. is not responsible for failure to observe Good Techniques in the construction of the
locking elements to motorize, or for any deformation that may occur during use.
7. Before attempting any job on the system, cut out electrical power and disconnect the batteries.
Be sure that the earthing system is perfectly constructed, and connect it metal parts of the lock.
8. Use of the indicator-light is recommended for every system, as well as a warning sign well-fixed
to the frame structure.
9. SEA S.p.A. declines all liability as concerns the automated system’s security and efficiency, if
components used, are not produced by SEA S.p.A.
10. For maintenance, strictly use original parts by SEA.
11. Do not modify in any way the components of the automated system.
12. The installer shall supply all information concerning system’s manual functioning in case of
emergency, and shall hand over to the user the warnings handbook supplied with the product.
13. Do not allow children or adults to stay near the product while it is operating. The application
cannot be used by children, by people with reduced physical, mental or sensorial capacity, or by
people without experience or necessary training. Keep remote controls or other pulse generators
away from children, to prevent involuntary activation of the system.
14. Transit through the leaves is allowed only when the gate is fully open.
15. The User must not attempt to repair or to take direct action on the system and must solely
contact qualified SEA personnel or SEA service centers. User can apply only the manual function
of emergency.
16. The power cables maximum length between the central engine and motors should not be
greater than 10 m. Use cables with 2,5 mm2 section. Use double insulation cable (cable sheath) to
the immediate vicinity of the terminals, in particular for the 230V cable. Keep an adequate distance
(at least 2.5 mm in air), between the conductors in low voltage (230V) and the conductors in low
voltage safety (SELV) or use an appropriate sheath that provides extra insulation having a thickness
of 1 mm.
GENERAL NOTICE FOR THE INSTALLER AND THE USER
37