ATTENTION: Program the radio controls before connecting the antenna and inserting the receiver
into the appropriate CNS connector (if available) with the FIX RF module it will be possible to use
only fixed code radio transmitter. Select the 2-TRANSMITTERS on the display and press OK, at
this point using the UP and DOWN buttons, select the command to associate the button (maximum
2 commands can be associated) and press OK to confirm the choice, now press the button of the
radio transmitter that you want to associate. If the memorization has been successful, the message
“Memorized” will appear on the display.
In MENU 2-TRANSMITTERS MENU it is possible to select the items: “Start” (to associate a Start
command), “Pedestrian Start” (to associate a Pedestrian Start command), “Stop” (To associate a
STOP command to the TX ), “Delete memory” (To delete all the TXs), “Delete one TX” (To delete the
single TX but if it is a Rolling Code Plus transmitter), “Release” (to associate the TX with the electric
brake release). To release the electric brake it is necessary to give 3 consecutive impulses, the 4th
impulse will reactivate the electric brake lock.
Note:
- Perform radio control learning only with control unit switched off and
closed the gate.
- It will be possible to memorize up to a maximum of 16 codes (buttons), by adding the MEM
memory it will be possible to memorize up to 496 different codes.
- It is possible to memorize up to 2 of the 4 functions available. If a code is received that had already
been assigned to a function it will be updated with the new function.
DELETING THE TX FROM THE RECEIVER
With FIX RF modules, it will be possible to delete only the entire RX memory. Proceed as follows:
select the “Clear memory” in the 2-TRANSMITTERS menu and keep the OK button pressed until
“OK” appears on the display.
Connect the receiver to the CNS
connectors, respecting the direction
in the figure .
rADIo CoNTroL SELF-LEArNING WITH FIX rECEIVEr
oN BoArD
ENGLISH
13