SINGLE MOTOR and DRY CONTACT CONNECTION
MOTOR 1
Motor connection 1
The motor must be connected to the terminal block
CN2 of the Inverter module, in terminals U, V, W.
Motor to be connected in the case of a single leaf.
In the case of two motors, connect the second
motor to the second Inverter module, again in the
CN2 terminal board.
Clean contact (C. 5A DRY)
Clean contact can be set in the 134 relay PV 1
Module menu.
Note:
on the BIG motor it is set by default as photocell
negative
brake management
POWER INPUT
To connect the power supply, follow the regulations
in force.
Note:
it is mandatory to connect the earth cable to the PE.
PROGRAMMABLE INPUTS GP1 AND GP2
OUTPUT MANAGEMENT CR1 AND CR2
COMIS INPUT FUNCTION
These inputs can have different functions, depending on how they are set in menus 130 and 131
These two outputs CR1 CR2 are clean contacts whose functionality depends on how the menus
132 and 133 are set
The COMIS input can be used as common for accessories up to a maximum load of 350 mA, the
exceeding of the maximum load will be reported
ENGLISH
22