Screen Print & Inkjet Fast T-Jet Blazer Pro, Руководство пользователя

Страница: 39 / 138

would be used:
At the UI, turn the printer OFF using the 1. Emergency button.
Turn the printer ON and allow it to go through a start-up cycle. 2.
On the UI, press the “RIGHT hand” button until the 3. Mode Select screen
appears. (Refer to page 45 for details on UI screens)
In the upper left hand corner is a virtual dial pointing to “Auto.” Press the dial
4.
once and it will rotate to “Manual.”
Using the “hand” buttons, scroll through the UI screens until you reach the
5.
MMMU screen.
Press the 6. Jog button until the printer is over a shirtboard.
Lift the printer cover if it is not already. Locate the Carriage Release button, 7.
press and manually move the Print Carriage until its sits over the 3rd
Shirtboard.
On the UI, use the “hand” arrows to browse through the screens until you
8.
find the Platen to Head Clearance Adjust (PHCA) option.
Use the UP/DOWN arrows to set a Print Head clearance of approximately 9.
3 mm . What actually moves up and down is the Platen, NOT the Print
Carriage. Therefore, the UP button raises the Platen closer to the Print Head
and the DOWN button lowers the Platen away from the Print Head.
After adjusting the Platen to Print Head height, ensure the
10. 3mm gap is
maintained across the span of ALL THREE Shirtboards.
Slide the Print Carriage back to the capping station
11.
Return to the UI and navigate through the screens until you are once again 12.
at the MMMU screen. Under the Position heading, press Home .
You will hear an audible tone and the Printer Assembly will begin to move. When
it stops, it will be in the Home position
25
Carriage
Release Button
Chapter 4- Initialization Utilities