Screen Print & Inkjet Fast T-Jet Blazer Pro, Руководство пользователя

Страница: 110 / 138

Fast T-Jet Blazer Pro User’s Manual
96
Problem:
The Print Head is leaking, dripping ink on garments.
Causes:
The Print Head may have been damaged by a collision
•
Order a replacement Print Head.
The Print Head is saturated with ink
•
Thoroughly clean the Capping Station. The Capping Station can
become dirty with garment lint or fibers as well as dried ink. This will
prevent it from adequately cleaning the Print Head.
Debris or shirt fibers have collected on the Print Head as well as the Print Head
•
Carriage
Gently clean the bottom of the Print Head to remove any debris, dried ink
and fibers. Also check the Capping Station to ensure it is clean and free of
debris and lint.
Too much ink is coming through the Print Head
•
If you filled the Bulk Ink Cartridges past the Full Line there could be too much
pressure in the bulk system ink lines, forcing ink out of the Print Head.
Altitude can have an effect •
The bulk ink system requires the proper vacuum pressure to siphon the ink into
the Print Head. If you are having an unusual amount of problems and are at
a higher altitude, don’t fill the ink bottles as full.
Faulty bulk system
•
Call Technical Support.
Prevention:
Always check the Platen to Print Head Clearance prior to printing.
•
Clean the Capping Station on a regular basis.
•
Clean debris from the Print Head daily. •
Do not overfill the Bulk Ink Cartridges.
•
Problem:
The printed image is wiping off, washing out, fading badly or bleeding.
Causes:
The garment was improperly cured
•
Garment ink requires a temperature of 330 degrees F. to cure properly. Apply
this heat for at least 60-90 seconds for Light garments and for at least 180-240
seconds for Dark garments
Too much or too little pressure was applied when Heat Pressing
•
When pressing the garment, the Heat Press should rest on the silicone or