Screen Print & Inkjet Fast T-Jet Blazer Pro, Руководство пользователя

Страница: 92 / 138

Choose a Print Mode. (For a list and description of the available Print Modes, 3.
please refer to your FastARTIST User’s Manual.)
Print to FastRIP. 4.
Finish with Fast T-Jet Non-Textile Post-Treatment
Fast T-Jet Non-Textile Post-Treatment is a protective coating used for prints on
non-textile surfaces. This post treatment will prevent fading of ink colors, extend
the life of the image as well as waterproofing and acting as a UV protectant.
DIRECTIONS:
Shake the can before each use and apply to non-textile, printed
surfaces only after all ink has dried thoroughly. Apply a thin coat,
holding the can 4 to 8 inches from surface and using a swift motion
to prevent overspray and unwanted build-up. If build-up does
occur, use a lacquer thinner to remove. A second coat may be
applied after approximately two minutes of drying time. Allow
treated surfaces to dry for 30 minutes to one hour in a clean, dust
free area before handling. Allow 24 hours cure time prior to placing
coated articles into service.
Clean the valve after use by turning the can upside down and spraying a
short burst until cleared. If the nozzle is clogged or sprays irregularly, check for
clogging within the opening. Scrape off excess coating with a soft object and
twist the valve one half turn to close.
78
Fast T-Jet Blazer Pro User’s Manual