Scout MT-700 ENT, Руководство по эксплуатации

Страница: 68 / 155

МТ-700 fleet tracking system 68
Battery disconnect switch –
– if the parameter is on, all the changes of the sensor is not
counted until the battery disconnect switch is off.
Figure 65. Digital input settings
If the checkbox “enable the pull-up” on the P3 is enabled – then the internal pull-up is enabled.
Analogue inputs settings on P0-P2
Analogue inputs are designed to measure sensors, which correspond to the change in
measuring parameter to the output voltage change. Those sensors are: fuel level sensors,
temperature sensors, etc.
Analogue ports can be configured as follows:
Ignition filtering– if the parameter is on, then the changes in the sensor are not counted until
the ignition is “ON”
Battery disconnect switch – – if the parameter is on, then the changes in the sensor are not
counted until the battery disconnect switch is off.
On the analog inputs the following sensors can be added:
«Fuel sensor» – filtration algorithm for fuel level sensors.
«Voltage» – for the arbitrarily sensors.