Scout MT-700 ENT, Руководство по эксплуатации

Страница: 83 / 155

МТ-700 fleet tracking system 83
Output blocking state –
terminal output state after the blocking command. High level
corresponds to a «ON».state, low level – «OFF».
Engine block on ignition off –
activating the block on the disabled ignition.
Parking block–
output activation on parking.
Block timeout (s) –
time delay before activating the output after the blocking message
acquisition.
Engine block length (ms) –
If specified, the output will be activated for the stated time. If the
value=0, output will be activated on the blocking command acquisition.
ON –
activates the output (after execution by the terminal).
OFF-
deactivates the output (after execution by the terminal).
Engine can be blocked using the SMS-command Setport with the following parameters
Command example:
setport 6,1
Response
:
id(setport): OK
.
Port status request for the Р 0- Р 7 ports
Port status can be requested using the SMS-command getport , the parameter – is the
port number.
Example:
getport 0
Response:
Id(getport): P0: PeakDetector=0
RS-485 port settings
RS-485 (ScoutNet) is used for local configuration of the tracker and external sensors
connection. Up to 8 sensors can be connected
In the МТ-700 PRO 285/ МТ-700 PRO RS-485 interface supports LLS, ScoutNet, J1708,
RFID, NMEA protocols.
In the МТ-700 ENT RS-485_1 interface supports ScoutNET protocol, RS-485_2 interface
supports LLS, J1708, RFID protocols.
In the МТ-700 Lite RS-485 interface supports ScoutNET protocol.
In the МТ-700 STD RS-485 interface supports LLS and ScoutNet protocols.
Protocols are not compatible. For the ENT version the ScoutNet protocol is supported
on the RS-485_1 and every other protocol can be used for the RS-485_2.