Scout Boats 380 LXF, Руководство пользователя

Страница: 151 / 210

151
Interior Equipment
Care should be exercised while operating the re-
frigerator on 12 volt power without the engines
running. It draws a substantial amount of cur-
rent and can severely drain the house batter bank
through extended use. The refrigerator slide out
drawer has a special latch to secure the drawer
while under way. Make sure the drawer is prop-
erly secured whenever the boat is moving. Refer
to the refrigerator owner’s manual for additional
operating and maintenance instructions.
Microwave Oven
A microwave is built into the cabinet above the
galley sink. The microwave operates on AC power
and is activated and protected by the Microwave
circuit breaker in the AC panel. Refer to the manu-
facturer’s operating manual for detailed informa-
tion on the microwave oven installed in your boat.
Berth and Dinette
A dinette is located in the forward section of the
cabin that converts to a berth. There is a hatch
below the forward center cushion that provides
access to the air conditioner. You should not store
dunnage in the forward compartment.
Other hatches below the port and starboard di-
nette seats and behind the backrest cushions pro-
vide storage and access to the hot and cold water
system valves, water heater, fresh water pumps
and other equipment mounted in the berth area.
Another hatch in the cabin sole provides access
to the overboard diaphragm discharge pump for
the waste tank, thru-hill discharge valve and the
sump pump for the air conditioner condensation
pan drain.
A table and removable pedestal converts the for-
ward cabin into a dinette or a berth. The pedestal
is stowed in special brackets in a storage compart-
ment behind the port dinette backrest cushion.
To convert the dinette to a berth, rotate the table
1/4 turn to release the base from the pedestal.
Remove the table and set it down next to the
dinette cushion. Rotate the pedestal 1/4 turn to
release the pedestal from the base plate and stow
the pedestal. Place the table on the supports on
each side and front of the dinette. Install the filler
cushions on the table to complete the conversion.
To convert the berth to a dinette, remove the filler
cushions. Install the pedestal on the cabin sole
base plate and rotate it 1/4 turn to lock it to the
plate. Place the table base plate on the pedestal
and rotate the table 1/4 turn to lock the table to
the pedestal. Store the cushions.
Dinette Seat Cushions
Dinette Converted To Berth
Table Pedestal In Storage Brackets
To avoid damage to the table and pedestal, always
make sure the table is in the berth position when-
ever the boat is operating above slow speed. This
is particularly important when the boat is being
run offshore.
https://www.boat-manuals.com/