Mounting and adjustments, size 10 - 14
CAUTION
Material damage due to erroneous settings!
Due to erroneous adjustment of the angle of rotation, individual
components may become loose and the product may be
damaged and its seal broken.
•
Only trained staff may set the angle of rotation.
•
Before setting the angle of rotation, relieve the pressure.
Adjust end positions - absorber variant -E (with elastomer) or -
H / -S (with hydraulic stop)
1. Loosen set-screw (B1).
2. Apply pressurized air to air connection "A".
3. Open the exhaust air throttle valve at the air connection "B"
approx. two turns until the pinion (1) moves to the end
position "E1".
4. Turn the adjusting sleeve (B2) and set the desired end position.
IMPORTANT! Observe permissible adjustment range.
5. Check end position.
✓
To do this, ventilate air connection "A" and pressurize it
again, if necessary adjust end position.
6. Tighten set-screw (B1).
✓
Tightening torque: SRM 10-E / -H: 0.4 Nm;
SRM 12-E / -H: 0.6 Nm; SRM 14-E / -H / -S: 0.7 Nm
✓
End position "E1" is set.
7. Adjust other end position analogously.
8. Swivel repeatedly to test the setting, adjust if necessary.
49
12.00 | SRM | Assembly and Operating Manual | en | 1346850
