SATO CW408, Руководство оператора, Страница: 43 / 120

Section 3: Operation and Configuration
CW408 Operator Manual Page 3-17
3.9 OPERATION SETTINGS MODE (Cont’d)
3. When the desired setting option is displayed, press the LINE button to set the value or select an item.
Then press the FEED button to shift the cursor to the next digit or to save the setting and move to the next
screen.
Do a test print after completing the adjustments to make sure that the settings are correct. Refer to Section
3.14 Test Print Mode for details.
OP SETTINGS
Menu Description
To set the Operation mode.
Allows the choice of continuous feed or tear-off operation. If cutter or dispenser
has been correctly installed, the respective option will be displayed.
When TEAR OFF or CONTINOUS is selected, the printer will proceed directly
to MEDIA TYPE screen.
When CUTTER or DISPENSER is selected, the printer will proceed to BACK-
FEED MOTION screen.
The initial setting is:
TEAR OFF (When option is not installed)
CUTTER (When cutter is installed)
DISPENSER (When dispenser is installed)
Determines whether or not a backfeed motion will be applied. If so, the selec-
tion of before or after the printing is available.
These screens are displayed only when CUTTER or DISPENSER is selected
for OPERATION MODE.
AFTER : Perform backfeed motion after printing (Motion 1).
BEFORE : Perform backfeed motion before printing (Motion 2).
NONE : No backfeed motion. NONE screen does not display in DISPENSER
mode.
The initial setting is BEFORE.
To set the media type use for the printer.
These screens are displayed only when a selection other than DISPENSER is
chosen in the operation mode.
FAN - FOLD : Select when using fan-fold media.
ROLL : Select when using media roll.
The initial setting is FAN-FOLD.
Set the pitch sensor to be selected relative to the media type to be used.
GAP : Detects media pitch by the transmissive sensor.
I-MARK : Detects media pitch by the reflective sensor.
NONE : No sensor is used.
The initial setting is GAP.
Note: You cannot select NONE when TEAR OFF or DISPENSER is selected in
the operation mode.
The display brightness will dim to save power when the printer is not operated
for a specified period of time.
Set the time between 00 to 15 MIN.
This power saving function is disabled when it is 00 MIN, and the brightness of
the display will be lit constantly. The initial value is 00 MIN.
OP SETTINGS
OPERATION MODE
CONTINUOUS
OP SETTINGS
OPERATION MODE
DISPENSER
OP SETTINGS
OPERATION MODE
CUTTER
OP SETTINGS
OPERATION MODE
TEAR OFF
OP SETTINGS
BACKFEED MOTION
AFTER
OP SETTINGS
BACKFEED MOTION
NONE
OP SETTINGS
BACKFEED MOTION
BEFORE
OP SETTINGS
MEDIA TYPE
ROLL
OP SETTINGS
MEDIA TYPE
FAN-FOLD
OP SETTINGS
SENSOR TYPE
NONE
OP SETTINGS
SENSOR TYPE
I-MARK
OP SETTINGS
SENSOR TYPE
GAP
OP SETTINGS
BRIGHTNESS TIMER
MIN 00
Preliminary