Section 2: Installation
CW408 Operator Manual
Page 2-11
2.4 HOW TO LOAD THE MEDIA (cont’d)
2.4.4 How to Load Label to the Optional Dispenser
Use only roll label with the optional dispenser. It is not advisable to use labels with perforation when using the
optional dispenser. Fan-fold media always has perforation.
Note:
Automatic media feed function is disabled when the dispenser unit is installed.
1.
Install the optional
media roll holder
to the printer.
Follow step
1
to
4
of
Section 2.4.3 How to Load the Media Roll (Option)
2.
Press the
cover open latch
on the right side of the
printer to open the
top cover
of the printer. The
top
cover
will open upwards.
3.
Push the two
dispenser unit open latches
inwards
to open the
dispenser bracket
.
4.
Pull down the
media guide lever
of the
printer
to
release the
media guide
of the printer. Adjust the
media
guide
to the media size.
5.
From the leading edge of the label, peel off the first few
labels until the liner is about 100 mm (3.9”) long.
6.
Insert the leading edge of the liner into the
media feed
inlet
of the printer and pass through the
media guide
.
2
1
1
2
4
3
3
4
Preliminary
Содержание CW408
Страница 98: ...Section 6 Basic Specifications Page 6 8 CW408 Operator Manual This page is intentionally left blank Preliminary...
Страница 106: ...Section 7 Interface Specifications Page 7 8 CW408 Operator Manual This page is intentionally left blank Preliminary...
Страница 119: ...Section 8 Appendix CW408 Operator Manual Page 8 13 This page is intentionally left blank Preliminary...