SATO CW408, Руководство оператора, Страница: 23 / 120

Section 2: Installation
CW408 Operator Manual Page 2-9
2.4 HOW TO LOAD THE MEDIA (cont’d)
2.4.3 How to Load the Media Roll (Option)
The media roll can only be used with the optional media roll holder.
Attach the optional media roll holder and load the media roll to the printer.
1.
Attach the optional media roll holder to the printer.
Set the printer with the two holes at the rear bottom to
the protrusion post of the
media roll holder .
2.
Pass the power cord and the interface cable through the
holes at the rear or side of the
media roll holder and
connect to the printer.
3.
Adjust the width of the media guide on the shaft
to match the media size. Put the shaft into the core of
the media roll and set the core in between the media
guide .
4.
Put the shaft onto the top horizontal frame of the
media roll holder .
Make sure that the groove on both sides of the shaft
are attached to the frame .
Make sure that the printed side of the media roll is facing
upward.
1
1
2 3 4 4
2 3
4
5
4
5
Preliminary