SATO CW408, Руководство оператора, Страница: 77 / 120

Section 4: Cleaning and Maintenance
CW408 Operator Manual Page 4-3
4.2 HOW TO CLEAN THE PRINTER (CLEANING KIT) (Cont'd)
9.
Locate the I-mark sensor and Gap sensor on the left
media guide .
10.
Dab a cotton cloth with the same cleaning solution. Clean
any foreign matter from the exposed surface of the
media
guides and sensor . Insert the cotton cloth in the slot of the
media guide and briskly clean it with a back and forth
motion.
11.
Repeat the cleaning procedure when it is necessary. The
platen roller should be cleaned whenever foreign matter,
such as dust or adhesive, is present.
4.3 HOW TO CLEAN THE PRINTER (CLEANING SHEET)
If the cleaning kit does not clean the stubborn debris on the print head, clean the print head with the cleaning
sheet.
1. Set the printer to off.
2.
Remove the AC power cord.
3.
Lift the top cover .
4.
Remove the media.
5.
Put the print head cleaning sheet between the print
head and the platen roller . Make sure that the coarse
side of the cleaning sheet points to the surface of the
print head elements.
6.
Close the top cover with approximately 25 mm (1 inch)
of the cleaning sheet extended out of the printer.
7.
Use one hand to hold the printer, while the other hand
slowly pull the exposed cleaning sheet outwards until it
is removed.
8.
Do the procedure again two to three times from steps 3
to 7.
9.
You can stop to clean with the cleaning sheet when no
more additional dirt appears on it.
10.
Use the cleaning pen from the cleaning kit or use a
cotton swab moistened with head cleaner to gently
remove any remaining dirt from the
print head .
I-mark and Gap
sensor is
underneath the
media guide
Media guide
Cotton cloth
Preliminary