SATO CW408, Руководство оператора, Страница: 83 / 120

Section 5: Troubleshooting
CW408 Operator Manual Page 5-3
5.1 ERROR SIGNAL TROUBLESHOOTING (Cont’d)
No. ERROR DISPLAY LED/ BUZZER ERROR CONDITION CORRECTIVE ACTION
14 DOWNLOAD DATA
ERROR
ONLINE: Off
ERROR: On
Message: DOWN-
LOAD DATA ERROR
1 long beep
1) Received invalid data.
2) Not enough download
area
To clear error: Press the
FEED button
1) Check downloaded data.
2) Check the size of downloaded
data.
15 CUTTER ERROR ONLINE: Off
ERROR: Blinks
Message: CUTTER
ERROR
3 short beeps
1) Media was jammed at the
cutter unit.
2) Cutter’s blade does not
return to the original
position.
To clear error: Press the
FEED button
1) Clean the cutter unit.
2) Press the FEED button and move
the cutter blade to the original
position.
21 KANJI DATA ERROR ONLINE: Off
ERROR: On
Message: KANJI
DATA ERROR
3 short beeps
1) Reading invalid Kanji data
that was imported to Kanji
memory.
To clear error: Power off
1) Replace PCB board.
26 OVERHEAT ERROR ONLINE: Blinks
ERROR: Blinks
Message: PRINTER
OVERHEATED.
PLEASE WAIT.
1 long beep
1) Printer's temperature is
beyond the allowable
range.
To clear error: Stop
operating the printer and
cool it down
1) Stop operating the printer and let
it cool down.
27 COMMAND ERROR ONLINE: Off
ERROR: Blinks
Message: INVALID
DATA
3 short beeps
1) Invalid command or
parameter was found in
print data.
2) Print ratio per media
exceeded 50% (416 dots)
when using Print
darkness level B.
[Note]
• This screen appears
when setting [DISPLAY
ERROR] to “ENABLE”.
• Detected command
information will be shown
at the bottom of the
screen.
To clear error: Leave the
printer for a certain period.
Press the LINE button
1) Confirm print data.
2) Adjust print layout so that print
ratio is lower than 50%.
ERROR14
DOWNLOAD DATA E
ERROR15
CUTTER ERR
ERROR21
KANJI DATA
ERROR26
PRINTER OV
ERROR27
INVALID DATA
Caaa:<bb>:cc
Preliminary