Rvision SEE, Руководство по установке и эксплуатации

Страница: 52 / 64

A-6
RVision P/N
660904-01
Rev 1
SEE™ Setting up the SEE™ IP Camera
Port
Network base ports are used for communication between systems. Port numbers
must be identically set.
Multicast
The multicast IP address selection range is between 224.0.1.0 and
238.255.255.255. “Media Protocol” must be set to “Multicast”. The multicast address
must be the same for the system to be connected using multicast protocol.
Flow Control Mode
Three flow control modes can be chosen:
Serial Port Configuration - Unsupported
Using the Video Surveillance Serial Port window to manipulate SEE™IP systems is
not recommended.
Configuring the Video
Video compression and setting actions in response to certain events are featured in
this section. The cameras performance is defined by these settings and the capabil-
ity of the network and client computer.
Contact
techsupport@visionusa.com
if you need system setup recommendations.
Min
Bitrate adjusted to client with smallest net-
work bandwidth
Max
Bitrate adjusted to client with largest net-
work bandwidth size
Adjust Bitrate is adjusted to optimum rate
Off Flow control is off.