Rvision SEE, Руководство по установке и эксплуатации

Страница: 12 / 64

SEE™ Setup and Operations Manual
Page 4 RVision P/N
660904-01
Rev 1
Click the hypertext link to jump to the page for detailed instructions about a proce-
dure.
1. “Mounting the QuickConnect Mount/Cable to a Pole” on page 4
2. “Mounting the Camera” on page 5
3. “Connecting the RS-232 connector to a PC” on page 7
4. “Connecting Power to the Camera” on page 8
5. “Connecting to the LOOK™ Controller” on page 8
6. “Running the pSEE™ Application” on page 12
7. “Connecting to Third Party Controllers” on page 13
Mounting the QuickConnect Mount/Cable to a Pole
The SEE™ is shipped with a QuickConnect Mount/Cable and the correct cable length
segment.
Figure 3: QuickConnect Mount Cable with a Thule clamp
To mount the QuickConnect Mount/Cable to a Thule rack perform the following
steps.
1. Loosen but do not remove QuickConnect fasteners.
2. Slide QuickConnect around horizontal Thule rack.
3. Tighten QuickConnect fasteners.
4. Route the QuickConnect cables to the computer or LOOK controller.
Note: Clamp mount assemblies include fasteners and a wrench.